The camber plates are shaping up - they are not the smartest design in terms of bolt loadings - they sit on top of the towers and all the tension loads for the front struts to the body go through the nuts and thread lands (i.e. bolt is in tension - with reversing loads) so the holes are being reamed 5/16 and and close tolerance AN5-10 bolts being used with aircraft lock nuts and nordlock washers. I will lock the bolt heads in place - somehow
that's the good bit - the bad bit is that due to some project cost overruns in real life the roll cage is back on the deferred list - if I can sell a spare Volvo and probably my Mi16 Peugeot I f can get back into things but not right at the moment
work will continue on body prep - throttle pedal fabrication - steering shaft fabrication fuel tank location and set up plus resolving the flare issue. I will also need wheel studs and wheel bearings solid suspension bushes - steering pinion machining and brake calliper tidy up etc.....
T minus 3 weeks and holding
blast
w
No comments:
Post a Comment